diy hook up ice maker

Marie Freeman, 24 years old


About me:
When purchasing a new refrigerator, you forgot an important addition, an ice maker. Sounds hard you say? Not really. With a few tools and fifteen minutes, you can install an ice maker in your refrigerator. Open the freezer door and remove the plastic plugs on the back diy hook up ice maker side of the freezer walls by gently prying them out with a straight blade screwdriver. The two on the side are the mounting holes for the ice maker.

Refrigerators with automatic ice makers are a great convenience, especially on a hot day. However, there is nothing automatic about getting a water line hooked up to the ice maker. If you are lucky, there will be a hookup in your kitchen wall near the refrigerator. If not, you will need to run a line to the nearest cold water pipe, diy hook up ice maker is probably in the floor below your kitchen. An hour project of drilling and running flexible hose is well worth the pleasure of ice on demand. Select the location for the valve on your water line.

The first step is to run the water line. Drill a hole behind the refrigerator, and then one underneath the sink. Go down into the crawl space. Feed the line down, and then up through the refrigerator hole. Whenever drilling holes for water lines, always be sure to use a paddle bit that's one to two sizes larger than the water supply line to prevent the line from kinking. Now that the water line has been run to the refrigerator, it's time to do what's called the "tap-in" to the cold water line underneath the sink.
Interests:
More about diy hook up ice maker:
An ice maker is a small appliance that fits in the freezer compartment of a refrigerator. It is fed by a small tube that runs up the back of the refrigerator to an inlet valve. When the refrigerator senses that more ice cubes need to be made, the inlet valve opens and lets water flow into a special ice cube mold. To get the ice maker running, you must hook up a special type of hose from the refrigerator connection to a water source. This kit consists of 6 feet of flexible tubing called PVC hose with a built-in compression nut at both ends. Since compression nuts come in different sizes, check the manual for the size that will be needed for your model of refrigerator. You will also need a small crescent wrench and some latex tape. Step 1: Locate the refrigerator connections at the base of your refrigerator, referring to the installation manual for a picture of what the connection should look like. Step 2: Remove the PVC hose from the diy hook up ice maker and note the compression nuts located on both ends of the tube. Step 3: Thread one end onto the water shutoff valve, located in the wall behind your refrigerator.

diy hook up ice maker

mila kunis dating 2013 dating manado best russian dating sites photos dating agencies hampshire area job dating le havre phone dating numbers free dating las vegas

most marriages dating sites teenage dating sites safe patiala dating site simpsons marge speed dating dating sites for couples radiocarbon dating could be used to date fun dating sims